Blue Sea Systems 9003E e-Series Battery Switch Single Circuit ON/OFF

Blue Sea 9003E E-Series Master Battery Switch Single Circuit ON/OFF

• Blue Sea 9003E E-Series Master Battery Switch Single Circuit ON/OFF Marine Boat
• Battery switches isolate the potentially destructive energy in the battery banks when the boat is not in use or during emergencies.
• Continuous Rating The maximum current a switch is designed to conduct for an indefinite period. - 350A
• Terminal Stud Size - 3/8" - 16 (M10)
• Stud Material - Tinned Copper

Blue Sea 9003E E-Series Master Battery Switch Single Circuit ON/OFF Marine Boat

Specifications:

Switch Type - Single Circuit ON-OFF

Color - Red

Switch Positions - 2

Battery Combine - No

Alternator Field Disconnect Alternator Field Disconnect protects the diodes in the alternator in the event of the switch being switched to the OFF position while the engine is running. if the AFD is not used to protect the alternator, an LED can be connected to the AFD terminals to indicate when the battery switch is in any position but OFF. - No

Maximum Voltage - 48V DC

Terminal Stud Torque - 140 in-lb (15.82 Nm)

Continuous Rating The maximum current a switch is designed to conduct for an indefinite period. - 350A

Intermittent Rating The maximum amount of current a switch is designed to carry for a minimum of a designated period of time. - 600A (5 min)

Cranking Rating 30 sec Normally associated with 'cranking current' which is the current required by the starter circuit prior to engine starting. The cranking current varies significantly during the starting cycle. Initially, there is a large surge of current required to overcome the inertia and compression of the engine. This surge can be two to four times the average cranking current. Once the engine is turning there are peaks and valleys as the pistons go through the compression and exhaust cycles. The cranking current rating is used for sizing batteries, cables, and battery switches. - 1200A

Battery Inputs - 1

Cable Clearance For 4/0 AWG Cables - 1.10in (27.94 mm)

Cable Size to Meet Ratings - 4/0 AWG (120mm²)

Mounting Holes - Accept 1/4" (M6) Screw

Stud Material - Tinned Copper

Terminal Stud Size - 3/8" - 16 (M10)

Weight - 1.30lb (0.59 kg)